![]() The menu structure is shown in the Calibrator Map located near the end of this. The MillipaK is designed to work with the Calibrator currently in use with SEVCON's MOS90 system. ![]() H��U]o�6|ׯا�B#Z�dI.\����M}�#�>5r��]V�e�̄�yH��U�čV_��j\�j���]rE�REn�؝ qU�RU^W� $N��2W�2�˧^�J�X֑��S. Short-term rental of a SEVCON Millipak programming dongle. MillipaK 4QPM Controller Manual 27/02/02 Calibrator The Calibrator is a hand-held adjustment unit which can be used to configure and test the system. 24-volt default setting.\r\rIf not using seat switch \(Pin 5\), replace switch with jumper wire to B-.\r\rPin 4 should not be connected until after controller is turned on.\r\rController should be mounted to a paint free metal surface with thermal transfer grease.\r\rAccelerator potentiometer should travel from 0 to 5k for Min to Max speed.\r\rFuses are recommended in case of wiring short circuit.) ![]() Pin 4 should not be connected until after controller is turned on.Ĭontroller should be mounted to a paint free metal surface with thermal transfer grease.Īccelerator potentiometer should travel from 0 to 5k for Min to Max speed.įuses are recommended in case of wiring short circuit.) The green LED will turn 'on' and shine continuously when the MOS 90 is powered up and working correctly. If not using seat switch \(Pin 5\), replace switch with jumper wire to B-. The MOS 90 has a green diagnostics LED in the front panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |